Hewlett-Packard 8200ZL Manual

A SERVICE OF

next previous

<any|host <DA>|DA/<prex-length>>

[comparison-operator <value>]

[established]

[ack][n][rst][syn]

<icmp>

<any|host <SA>|SA/<prex-length>>

<any|host <DA>|DA/<prex-length>>

[0-255 [0-255]|icmp-message]

[dscp <precedence|codepoint>]

[log]

Insert an ACE or a remark by assigning a sequence number:

ProCurve(cong)# ipv6 access-list <name-str>

ProCurve(cong-ipv6-acl)# <seq-#> <deny|permit|remark>

Note: The deny and permit keywords use the options show above

for "Create and IPv6 ACL".

Delete an ACE or a Remark (or both) by sequence number:

ProCurve(cong)# ipv6 access-list <name-str>

ProCurve(cong-ipv6-acl)# no <seq-#> [remark]

Note: You can also delete an ACE by entering no <permit|deny>

followed by the settings explicitly congured for that

ACE.

Resequence the ACEs in an ACL:

ProCurve(cong)# ipv6 access-list resequence <name-str><starting-#>

<increment>

Enter a Remark:

ProCurve(cong)# ipv6 access-list <name-str>

ProCurve(cong-ipv6-acl)# remark <remark-str>

Remove a Remark:

Immediately after entry:

ProCurve(cong-ipv6-acl)# no remark

After entry of an ACE:

ProCurve(cong-ipv6-acl)# no <seq-#> remark

Delete an IPv6 ACL:

ProCurve(cong)# no ipv6 access-list <name-str> vlan

Enable or Disable an IPv6 VACL:

ProCurve(cong)# [no] vlan <vid> ipv6 access-group <name-str> vlan

Enable or Disable a Static Port ACL:

ProCurve(cong)# [no] interface <port-list|trkx> ipv6 access-group <name-str> in

ProCurve(eth-<port-list|trkx>)# [no] ipv6 access-group <name-str> in

61© 2009 Hewlett-Packard Development Company, L.P.

access-listCommand Line Interface Reference Guide