enabled, the device cannot become Querier for the subnet
unless the VLAN has an IP Address (use the 'show ip' command
to determine this). Each subnet must have at least one IGMP
Querier-capable device in order for IGMP to function
properly. The querier interval setting modies the time (in
seconds) between IGMP queries.
Next Available Option:
■ interval < 5 to 300 > -- Sets the interval in seconds between IGMP queries (default: 125) (p. 728)
■ [no] vlan VLAN-ID ipv6 mld querier
Usage: [no] vlan < vid > ipv6 mld querier
Description: This command disables or re-enables the ability for the switch
to become querier if necessary. The no version of the command
disables the querier function on the switch.
The show ipv6 mld cong command displays the current querier
command. (Default Querier Capability: Enabled.)
rapid-commit
■ [no] vlan VLAN-ID ipv6 address dhcp full rapid-commit
Obtain IPv6 address quickly from DHCPv6 server.
reachable-time
■ [no] vlan VLAN-ID ipv6 nd reachable-time
Usage: [no] ipv6 nd reachable-time <milliseconds>
Description: Congures the length of time neighbors are considered
reachable after being conrmed as reachable via the
neighbor unreachability detection algorithm. This value
appears in router advertisements sent on this interface and
is also used to manage the neighbor table entries on this node.
Next Available Option:
■ number < 1000 to 3600000 > -- Configures the router lifetime sent in router advertisements(p.
738)
receive
■ vlan VLAN-ID ip rip receive < V1-only | V2-only | V1-or-V2 | ... >
Dene RIP version for incoming packets.
Supported Values:
■ V1-only -- Accept RIP version 1 updates only.
■ V2-only -- Accept RIP version 2 updates only.
■ V1-or-V2 -- Accept both RIP 1 and RIP 2 updates.
■ disabled -- Do not accept RIP updates.
■ vlan VLAN-ID ip rip IP-ADDR receive < V1-only | V2-only | V1-or-V2 | ... >
Dene RIP version for incoming packets.
745© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
