Next Available Options:
■ access-group -- Apply the specified access control list on this VLAN interface (ASCII-STR) (p.
713)
■ address -- Set IP parameters for communication within an IP network(p. 713)
■ proxy-arp -- Enable/disable proxy ARP(p. 744)
■ local-proxy-arp -- Enable/disable local proxy ARP(p. 733)
■ bootp-gateway -- Add or remove the gateway address to be used for stamping incoming DHCP
requests(p. 720)
■ helper-address -- Add or remove a DHCP server IP address for the VLAN (IP-ADDR) (p. 726)
■ forward-protocol -- Add or remove a UDP server address for the VLAN(p. 724)
■ igmp -- Enable/disable/configure IP Multicast Group Protocol (IGMP) feature on a VLAN(p. 727)
■ irdp -- Configure ICMP Router Discovery Protocol (IRDP)(p. 732)
■ ospf -- Enable/disable/configure Open Shortest Path First (OSPF) protocol on the VLAN
interface(p. 738)
■ rip -- Enable/disable/configure Routing Internet Protocol (RIP) on the VLAN interface(p. 746)
■ pim-dense -- Enable/disable/configure PIM-DM protocol on the VLAN interface(p. 739)
■ pim-sparse -- Enable/disable/configure PIM-SM protocol on the VLAN interface(p. 740)
■ mroute -- Configure IP Multicast Routing parameters on the VLAN interface(p. 736)
ip-addr
■ [no] vlan VLAN-ID ip address IP-ADDR/mask-LENGTH
Interface IP address/mask.
■ [no] vlan VLAN-ID ip bootp-gateway IP-ADDR
IPv4 address of the BOOTP gateway.
■ [no] vlan VLAN-ID ip forward-protocol udp IP-ADDR
IP address of the protocol server.
Next Available Options:
■ port-num -- UDP port number of the server. (TCP/UDP-PORT) (p. 741)
■ port-name < dns | ntp | netbios-ns | ... > -- (NUMBER) (p. 741)
■ [no] vlan VLAN-ID ip ospf IP-ADDR
Specify the IP address the request is for.
Next Available Options:
■ passive -- Configures an ospf interface as passive. (p. 739)
■ area -- Specify an OSPF area.(p. 716)
■ authentication-key -- Set simple authentication method and key.(p. 717)
■ authentication -- Disable authentication.(p. 717)
■ md5-auth-key-chain -- Set MD5 authentication method and key chain.(p. 734)
■ cost < 1 to 65535 > -- Set metric of this interface.(p. 721)
■ dead-interval < 1 to 65535 > -- Set dead interval in seconds; the default is 40.(p. 721)
■ hello-interval < 1 to 65535 > -- Set hello interval in seconds; the default is 10.(p. 725)
■ priority < 0 to 255 > -- Set priority of this router as a designated router.(p. 742)
■ retransmit-interval < 1 to 3600 > -- Set retransmit interval in seconds; the default is 5.(p. 746)
■ transit-delay < 1 to 3600 > -- Set transit delay in seconds; the default is 1.(p. 749)
729© 2009 Hewlett-Packard Development Company, L.P.
vlanCommand Line Interface Reference Guide
