This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Options:
■ dscp -- Specify DSCP policy to use. (p. 231)
■ priority < 0 | 1 | 2 | ... > -- Specify priority to use. (p. 265)
■ [no] interface svlan VLAN-ID qos
Usage: [no] qos [dscp <0|1...63|af11|af12|af13|af21|af22|af23|af31|af32|
af33|af41|af42|af43|ef|cs0..cs7|000000|000001...111111> |
priority <0-7>]
Description: Set VLAN-based priority. The 'dscp' or 'priority' must
be specied if 'no' is not used. Using 'no' congures
the switch not to apply a VLAN priority override to this
VLAN's packets.
This is a VLAN context command. It can be called directly
from the VLAN context or follow the 'vlan VLAN-ID'
command.
Next Available Options:
■ dscp -- Specify DSCP policy to use. (p. 231)
■ priority < 0 | 1 | 2 | ... > -- Specify priority to use. (p. 265)
querier
■ [no] interface vlan VLAN-ID ip igmp querier
Usage: [no] ip igmp querier [interval <seconds>]
Description: Specify querier/non-querier capability for the VLAN. IGMP
queries are not sent when the mode is disabled. When
enabled, the device cannot become Querier for the subnet
unless the VLAN has an IP Address (use the 'show ip' command
to determine this). Each subnet must have at least one IGMP
Querier-capable device in order for IGMP to function
properly. The querier interval setting modies the time (in
seconds) between IGMP queries.
Next Available Option:
■ interval < 5 to 300 > -- Sets the interval in seconds between IGMP queries (default: 125) (p. 240)
■ [no] interface vlan VLAN-ID ipv6 mld querier
Usage: [no] vlan < vid > ipv6 mld querier
Description: This command disables or re-enables the ability for the switch
to become querier if necessary. The no version of the command
disables the querier function on the switch.
The show ipv6 mld cong command displays the current querier
command. (Default Querier Capability: Enabled.)
269© 2009 Hewlett-Packard Development Company, L.P.
interfaceCommand Line Interface Reference Guide
