interface
OVERVIEW
Category:
configPrimary context:
show interfaces (page 560)Related Commands
Usage: [no] interface < [ethernet] PORT-LIST [...] | loopback <num> >
Description: Enter the Interface Conguration Level, or execute one
command for that level. Without optional parameters
specied, the 'interface' command changes the context to
the Interface Conguration Context Level for execution of
conguration changes to the port or ports in the PORT-LIST
or with loopback keywork it will change context to loopback
mode. Use 'interface ?' to get a list of all valid commands.
COMMAND STRUCTURE
■ [no] interface loopback < 0 to 7 > -- Enter the loopback Configuration Level (p. 248)
■ ip -- Configure various IP parameters for the Loopback (p. 240)
■ address -- Set IP parameters for communication within an IP network (p. 216)
■ ip-addr -- Interface IP address. (IP-ADDR) (p. 241)
■ ospf -- configure Open Shortest Path First (OSPF) protocol parameters on the interface (p.
256)
■ all -- Process the request for all IP addresses. (p. 219)
■ area -- Specify an OSPF area. (p. 221)
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p.
222)
■ backbone -- The backbone area (the same as 0.0.0.0). (p. 226)
■ cost < 1 to 65535 > -- Set metric of this interface. (p. 229)
■ ip-addr -- Specify the IP address the request is for. (IP-ADDR) (p. 241)
■ area -- Specify an OSPF area. (p. 221)
■ area-id -- Single integer or IP address style dotted decimal. (OSPF-AREA-ID) (p.
222)
■ backbone -- The backbone area (the same as 0.0.0.0). (p. 226)
■ cost < 1 to 65535 > -- Set metric of this interface. (p. 229)
■ interface port-list -- Enter the Interface Configuration Level, or execute one command for that
level ([ethernet] PORT-LIST) (p. 262)
■ arp-protect -- Configure the port as trusted or untrusted (p. 223)
■ trust -- (p. 279)
■ bandwidth-min -- Enable/disable and configure guaranteed minimum bandwidth settings for
outgoing traffic on the port(s) (p. 226)
■ output -- Enable/disable and configure guaranteed minimum bandwidth for outgoing traffic.
(p. 258)
■ queue1 < 0 to 100 > -- Specify min. bandwidth percentage for queue one outgoing traffic.
(p. 270)
■ queue2 < 0 to 100 > -- Specify min. bandwidth percentage for queue two outgoing
traffic. (p. 270)
■ queue3 < 0 to 100 > -- Specify min. bandwidth percentage for queue three outgoing
traffic. (p. 270)
204© 2009 Hewlett-Packard Development Company, L.P.
