Filter
Top Products
Pelco Manual C501M-B (10/97) 6-5
6.1.5.6 Adjusting Lens Zoom and
Focus Speed
The CM8500 System offers a simple way of adjusting
camera lens Zoom and Focus speeds for better address-
ing user needs. To adjust the Zoom or Focus speed of a
camera lens, proceed with the following:
1. Call up the camera to be edited.
2. On the keyboard press a value from 0 to 3 (0 being
slow speed, 3 being fast).
3. Then press the function to be edited (i.e., [Zoom
Wide], [Zoom Tele], [Focus Near], or
[Focus Far]).
4. Repeat steps 1-3 for each camera and each func-
tion to be edited.
Figure 49. Sequence Menu
07/09/93
Mon: 1 Cam: 3
SEQUENCE
2 INSIDE CAMERAS
3 PRODUCTION AREA 1
4 PRODUCTION AREA 2
5 PRESET SEQUENCE
6 ALL CAMERAS
3 MAIN ENTRANCE
8
7
1 OUTSIDE CAMERAS
LEVEL ONE
LEVEL TWO
6.1.6 Running a Sequence
Any authorized user can run a sequence on any moni-
tor accessible from the keyboard. When running a se-
quence, any cameras not accessible to the user will be
bypassed in the scanning sequence. Sequences utilize
the priority code of the user for camera control.
6.1.6.1 Starting a Sequence
There are two ways to run a previously programmed
sequence. The first is to enter the number of the se-
quence followed by the [SEQ] key. The sequence will
start automatically. The number of the sequence will
be displayed in the Status Bar.
The other way to run a sequence is to press the [SEQ]
key without first entering a sequence number. This will
cause the Sequence Menu to appear on the Data Moni-
tor. Refer to Figure 49. To run a sequence, move the
cursor to the desired sequence and press the [point]
button. The sequence will start running automatically.