Filter
Top Products
Pelco Manual C501M-B (10/97) 5-19
5.5.1.5 Pattern Assignment Form
The Pattern Assignment Form is used to provide a log
and brief description of each pattern programmed by
the CM8500 system. Patterns can only be used with
Spectra™ and Intercept
®
series receivers. Each receiver
has 60 seconds available for pattern programming.
NOTE: When programming a pattern, if the
pattern utilizes the full 60-second time allot-
ment, when that pattern is selected to run it will
only scan once and stop. The camera will then
be positioned at the end of the scan pattern. If,
however, the pattern is programmed for less
than 60 seconds, when the pattern is selected it
will run continuously until manually stopped.
CAMERA
(input)
NUMBER This is the number assigned to the
camera as defined by its input into
the CM8500 system.
LOCATION This is the physical location of the
camera.
RECEIVER
TYPE Enter the part number of the receiver
associated with the camera site.
Camera/Lens
Config. Enter the make and model of the
camera and lens used at the camera
site. You also may wish to include
focal length (2/3-inch, 1/2-inch) and
camera type (Color or B/W).
PATTERN
Description This section should contain a brief
description of what the pattern will
be viewing when accessed.
COMMENTS Use this section for any additional
comments regarding the pattern.
CAMERA (INPUT) NUMBER LOCATION
RECEIVER TYPE CAMERA/LENS CONFIGURATION
PATTERN DESCRIPTION:
COMMENTS:
PATTERN ASSIGNMENT FORM