Filter
Top Products
5. EDITING PATTERN DATA
38
KE-430F, BE-438F
5-6. Adding tension codes
1
Carry out steps 1 to 3 in “5-3. Switching to pattern editing
mode” to switch to pattern editing mode.
Press the
or key to move the work clamp/button
clamp to the desired position.
* Move it to a position other than the start of the section
(so that “.” is not displayed).
2
Press the TENSION ( ) keys to select the
desired tension code (T1 to T9).
・ The tension code will flash.
3
or
or
To add a tension code, press the ENTER key.
・ A new tension code will be added and the sewing
machine will return to pattern editing mode. As well
as this, a section will be added and the numbers for
subsequent sections will be incremented by 1.
If you would like to return to pattern editing mode without
adding a tension code, press the
or key.
If you would like to end pattern editing mode without
adding a tension code, press the TEST key.
2635B 2636B
2637B
For example, tension code T5
2414B 2638B 2404B
<If adding a T5 code at the 5th stitch in section 2>
Final stitch
Final stitch
2639B