Filter
Top Products
4. FUNCTION SETTINGS
14
KE-430F, BE-438F
Initial values for each application
No. KE-430F-03 KE-430F-05 KE-430F-0K KE-430F-0F BE-438F
260 -15 -15 -15 -15 10
261 45 50 45 45 -80
262 45 45 45 45 -50
263 45 45 45 45 -50
264 0 25 0 0 0
265 35 35 35 35 15
266 35 0 35 35 15
No. Setting range
Initial
value
Setting units Setting details
267
OFF, 1 − 99
(stitches)
OFF 1
If the overall feed timing (setting No. 260) has been changed
from the default value, this specifies the effective number of
stitches.
OFF: No limit
1 to 99: When the specified number of stitches from the
sewing start is exceeded, the feed timing returns to
the standard timing.
268
0 − 2
1 1
Changes the overall feed timing reference.
0: [Feed start reference] Makes the timing uniform at the start
of feed.
1: [Needle up reference] Changes the timing at the start of
feed so that the feed moves half the feed width when the
needle bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end
of feed.
430F: 0
269
0 − 2
438F: 1
1
Changes the feed timing reference for the first three stitches at
the sewing start.
0: [Feed start reference] Makes the timing uniform at the start
of feed.
1: [Needle up reference] Changes the timing at the start of
feed so that the feed moves half the feed width when the
needle bar is at its highest position.
2: [Feed end reference] Makes the timing uniform at the end
of feed.
270
0 − 2
2 2
Moving method to the sewing start point after the program is
changed
* However, operation for the "0" setting is always carried out
when No. 273 is set to ON.
0: Moves to sewing start position and then stops.
2: Home position detection is carried out, then moves to the
sewing start position and stops.
271 ON/OFF OFF -
Work clamp/button clamp standby position
ON: For the 430F, the center of the sewing area is the standby
position (escape point).
For the 438F, the front is the standby position (escape
point).
OFF: The sewing start position becomes the standby position.
272 ON/OFF OFF -
Reduced feed noise
ON: Enable (Operating speed is limited to 2500 sti/min.)
OFF: Disable
273 ON/OFF OFF -
Start switch operation after program is changed
ON: Moves to sewing start position and starts (program No.
illuminates)
OFF: Only moves to sewing start position (program No.
flashes)