Filter
Top Products
4. FUNCTION SETTINGS
10
KE-430F, BE-438F
4-4. List of memory switches
NOTE:
In standard memory switch setting mode (refer to the CD Instruction Manual), the bottom two digits only display memory
switch Nos. 00 to 49. The bottom two digits do not display memory switch Nos. 50 to 99.
Work clamp/button clamp settings (001 − 099)
No. Setting range
Initial
value
Setting units Setting details
001
OFF, 1 − 2
1 1
Work clamp/button clamp lift timing when sewing is complete
OFF: Does not lift automatically.
1: Lifts at the final stitch position.
2: Lifts after moving to the sewing start position.
051 ON/OFF OFF -
Work clamp/button clamp operation before moving to the sewing start
position
ON: The work clamp/button clamp can operate vertically even before
moving to the sewing start position.
OFF: The work clamp/button clamp cannot operate vertically before
moving to the sewing start position.
052 ON/OFF OFF -
Work clamp/button clamp operation during pause (split program)
ON: The work clamp/button clamp cannot rise automatically during a
pause (split program).
OFF: The work clamp/button clamp can rise automatically during a
pause (split program).
060
0 − 3000
(ms)
0 10
Time after the work clamp/button clamp drops until the upper shaft
starts rotating
070
1 − 2
1 1
Type of foot switch used
1: Foot switch
2: 2-pedal foot switch (option)
071
1 − 2
1 1
Foot switch operating mode
* Enabled when No. 070 is set to “1”. (Refer to page 22.)
1: (1st step) Drop Æ (2nd step) Start
2: (1st step) Drop to intermediate height Æ (2nd step) Drop and start
072
1 − 5
1 1
2-pedal foot switch operating mode
* Enabled when No. 070 is set to “2”. (Refer to page 23.)
1: (Work clamp switch 1st step) Drop, (Start switch) Start
2: (Work clamp switch 1st step) Drop to intermediate height Æ (Work
clamp switch 2nd step) Drop, (Start switch) Start
3: (While work clamp switch depressed to 1st step) Work clamp/button
clamp rises, (Start switch) Start
4: (Work clamp switch 1st step) Drop Æ (Work clamp switch 2nd step)
Start
5: (Work clamp switch 1st step) Drop to intermediate height Æ (Work
clamp switch 2nd step) Drop and start