Filter
Top Products
4. FUNCTION SETTINGS
13
KE-430F, BE-438F
Feed settings (200 − 299)
No. Setting range Initial value Setting units Setting details
430F:OFF
200 ON/OFF
438F:ON
-
Single stitch test feed
ON: During test feeding, the mechanism moves one stitch at a time
when the foot switch is depressed to the 2nd step (for a
2-pedal foot switch, when the start switch is depressed).
In addition, when the test indicator is illuminated, test feeding
will move forward one stitch at a time when the machine pulley
is turned by hand.
OFF: During test feeding, sewing starts and automatically
continues to the last stitch when the foot switch is
depressed to the 2nd step (for a 2-pedal foot switch, when
the start switch is depressed).
250 ON/OFF OFF -
Home position detection at the sewing end
ON: At the sewing end, the work clamp/button clamp will detect the
home position and then move to the sewing start position.
OFF: At the sewing end, the work clamp/button clamp will move to
the sewing start position.
251
1 − 5
3 1
Feeding speed
1: 100 mm/s (Slow)
2: 200 mm/s
3: 300 mm/s
4: 400 mm/s
5: 500 mm/s (Fast)
252 ON/OFF OFF -
High-speed test feed method
* Enabled when No. 200 is set to “OFF”.
ON: High-speed feeding starts at the same time test feeding starts.
OFF: Normally slow, but becomes faster when the foot switch is
depressed to the 1st step (for a two-pedal foot switch, when
the work clamp switch is depressed).
253
*1
0 − 2
0 1
Moving method to the sewing start point
0: Depress the foot switch to the 2nd step (for a two-pedal foot
switch, depress the start switch) while the program number is
flashing.
1: Press the RESET key while the program number is flashing.
2: Press the special external input switch (option input (IN3)) while
the program number is flashing.
260
-80 − 80
(degrees)
*2 1
Changes the overall feed timing
−: Feed timing becomes earlier.
+: Feed timing becomes later.
261
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 1st stitch at the sewing start
−: Feed timing becomes earlier.
+: Feed timing becomes later.
262
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 2nd stitch at the sewing start
−: Feed timing becomes earlier.
+: Feed timing becomes later.
263
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 3rd stitch at the sewing start
−: Feed timing becomes earlier.
+: Feed timing becomes later.
264
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 3rd stitch before the sewing end
−: Feed timing becomes earlier.
+: Feed timing becomes later.
265
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 2nd stitch before the sewing end
−: Feed timing becomes earlier.
+: Feed timing becomes later.
266
-80 − 80
(degrees)
*2 1
Changes the feed timing for the 1st stitch before the sewing end
−: Feed timing becomes earlier.
+: Feed timing becomes later.
*1: This is not initialized during initialization mode.
*2: The initial value will vary depending on the specifications. (Refer to “Initial values for each application” on the following
page.)