Filter
Top Products
Figure 8.1: D7039 Mounting Location
1 D7039 MUX Expansion module 5 Addresses 9 to 128
2 Enclosure 6 MUX Class A
3 FPD‑7024 Control board 7 Addresses 129 - 255
4 I/O module for the D7039 MUX
Expansion module
8 MUX Class B
AUTO PROGRAM
Shortcut: 0-PROG, 9-PROGRAM MUX, 4- AUTO PROGRAM
This option provides a convenient way for the installer to configure the FPD‑7024 to operate
with the existing devices on the multiplex buses by scanning the buses for missing or new
multiplex devices.
The following display appears:
AUTO PROGRAM?
_______:YES(1) NO(0)
Press [1] to continue with auto programming or [0/Prog] to cancel. When you press [1], the
FPD‑7024 checks for existing programming errors in which devices are programmed
incorrectly in the space required for a lower-addressed multi-point device (such as a dual
point module). If a point is found to be programmed under another device, the following error
message appears for five seconds, and the auto programming process aborts:
ADDRESS ERROR 1
AT ADDRESS xxx
If no errors are found, the FPD‑7024 starts a scanning process that takes approximately one
minute to complete, while showing the following display:
AUTO PROGRAM
SCANNING
PLEASE WAIT...
8.9.4
Fire Alarm Control Panels Control Panel Programming | en 93
Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458