Filter
Top Products
7- ALT.COMM
Phone Numbers/IP Addresses
Shortcut: 0-PROG, 6-PROG ACC’NTS, 1-PHONE/IP NUMS
The system can be programmed with two reporting phone numbers or IP addresses. Phone/
IP #1 is used with Account Number 1; Phone/IP #2 is used with Account Number 2. Remote
programming occurs on Line 1 using Phone/IP #3.
– PHONE/IP #1: Phone Number 1 or IP address 1
– PHONE/IP #2: Phone Number 2 or IP address 2
– COMPTR PHONE: Sets the Phone Number or IP Address to call for remote programming.
For acceptable programming selections for UL864 9
th
edition Listed applications, see
Programming features for UL864, 49.
The following window appears:
PHONE /IP NUMBER
1- PHONE /IP #1
2- PHONE /IP #2
3- COMPTR PH/IP
Press the number key that corresponds with the phone number you wish to configure
(example is Phone #1). The following window appears:
PHONE /IP NUMBER #1
1- NUMBER
2- PORT NUMBER
3- FORMAT
4- ACCT NUMS
5- TONE
Press the number key that corresponds with your selection. Refer to the next four sub-
sections (Number, Format, Account Numbers and Tone) for explanations of the phone number
options.
Number/IP address
The display scrolls through the Phone /IP Number options. Press [1] for NUMBER. The
following window appears:
PHONE /IP NMBR 1: >????
????????????????
Press [1]. Press [TEST][4] to add the wait for dial tone, and then enter the phone number and
press [#/Enter]. The previous menu appears. You can include several other special control
characters in the phone number by pressing [Test] followed by a digit.
For a list of control characters, see the following table:
Press
See Action
[TEST] 1 * Touch Tone “*”
[TEST] 2 # Touch Tone “#”
[TEST] 3 / Three-second delay
[TEST] 4 > Wait for dial tone
Table 8.3: Phone number control characters
8.6.1
78 en | Control Panel Programming Fire Alarm Control Panels
2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.