Filter
Top Products
5. Install and tighten the remaining two screws in the bottom mounting holes.
6. Knock out the desired wire entrances on the enclosure.
For mounting hole locations, see the following figure:
Figure 4.3: Enclosure iInstallation
1 Control panel location 5 Transformer
2 Mounting holes 6 Stud
3 Retainer holes for standoffs 7 Ground wire
4 Retainer holes for support posts
i
Notice!
If using the knockouts located at the bottom of the enclosure, install batteries in a separate
enclosure.
Installing the FPD‑7024
Danger!
The control circuit board in the FPD-7024 is static sensitive.
To avoid damage to sensitive components, touch ground before handling the control board.
This discharges any static electricity in your body. For example, run the ground wire to the en-
closure before handling the control circuit board. Continue touching the enclosure while in-
stalling the control board.
4.3
26 en | Installation Fire Alarm Control Panels
2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.