Filter
Top Products
Loop response
Shortcut: 0-PROG, 4-PROG INPUTS, 2-POINT FUNCTION
This feature allows you to configure points to activate with standard response time (setting 1)
or one system-wide programmed response time (setting 2).
Enter the point number you wish to program and press [#/Enter]. The display scrolls through
the PROG FUNCTION options.
Press [4/<] to select LOOP RESPONSE. The following window appears:
RESPNS TIME (___)
1- FAST (.5 sec)
2- PRGRMMD*
* For acceptable programming selections for UL864 9
th
edition Listed applications, see the
Programming features for UL864 table, 49.
Press the number key that corresponds to your selection (the existing setting is displayed in
parentheses on the first line). The previous window appears.
When you select a programmed response time, the system asks you to enter a response time
from 1 sec to 89 sec that applies to all functions. All functions share a single programmable
response time setting. If this time is set for multiple functions, the last time set is used.
When set for fast response operation, multiplex points typically have a response time.
Response time is (the maximum time an input must be held to guarantee an alarm) of
approximately 1 sec. Response time increases as points on the bus remain off-normal (in
alarm or with a loop or detector trouble), to a maximum of 20 sec in the extreme case of all
points on the bus being in trouble and one point in alarm. On a fully loaded system with only a
few points in alarm or trouble, fast response time remains at approximately 1 sec. For
programmed response, the response time tolerance is ±3 sec when only a few points are off-
normal, and increases by up to 20 sec when all points are off-normal.
On-board points have a response time tolerance of ±1 sec for programmed response time, and
+0.5 sec or - 0.25 sec for fast response time.
i
Notice!
Up to 20 points can be assigned to point functions that were programmed with a response
time other than Fast. If more than 20 points are assigned to functions programmed with a re-
sponse time other than Fast, an error message appears: MAX PROGRAMD POINTS EXCEE-
DED. Switching a point function from Fast to Programmed can cause this error, depending on
how many points reference the point function.
<DRILL> NEXT FCT: Pressing [Drill] retrieves the next function. For instance, if you are
programming Point Function 2 and you press [Drill], you retrieve the setting for Point
Function 3.
<HIST> PREV FCT: Pressing [History] returns you to the previous function. For instance, if you
are programming Point Function 2 and you press [History], you return to the setting for Point
Function 1.
Point copy
Shortcut: 0-PROG, 4-PROG INPUTS, 3-POINT COPY
Point copy allows you to copy the settings you entered for one point to one or more other
points.
The following window appears:
8.4.3
72 en | Control Panel Programming Fire Alarm Control Panels
2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.