Filter
Top Products
4/2 Report Codes
Shortcut: 0-PROG, 7-PROG FORMATS, 1-4/2 RPT CODS
4/2 Report Codes apply to system conditions but only when 3/1 or 4/2 format is selected. Two
digits can be programmed to be sent for each condition. The conditions that can be
programmed are:
– System in test, system in test restore: sent for walk test operations
Silence: sent when the silence key is pressed
Fire drill, fire drill restore: sent for fire drill operations
Open reset report: sent when the reset key is pressed
Low battery, low battery restore, AC failure, AC failure restore: sent for power problems
Test report: sent for manual or automatic communicator tests
Off normal at test: sent if the panel is off-normal at the automatic test time
Phone trouble, restore: sent for phone line problems
System trouble, restore: sent for general system problems
The following window displays:
4/2 RPT CODS
0- SYSTM IN TST
1- SYS TEST RST
2- SILENCE
3- FIRE DRILL
4- FIRE DRL RST
5- OPEN RST RPT
6- LOW BATTERY
7- LOW BATT RST
8- AC FAILURE
9- MORE
Pressing [9] allows programming additional reports:
4/2 RPT CODS
0- AC FAIL RST
1- TEST REPORT
2- OFF NORM TEST
3- PHONE 1 TRBL
4- PN 1 TRB RST
5- PHONE 2 TRBL
6- PN 2 TRB RST
7- SYSTEM TROUB
8- SYS TRB RST
Pressing [9] returns you to the previous group of reporting codes.
Press the number key that corresponds to your code selection. A window based on your
previous selection allowing entry of two hex digits appears:
8.7.2
Fire Alarm Control Panels Control Panel Programming | en 87
Bosch Security System, Inc. Installation and Operation Manual 2012.08 | 04 | F01U008458