Filter
Top Products
Programming relays
Shortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYS
The main control panel includes three on-board relays (Relay 1, Relay 2, and Relay 3). The
FPD‑7024 can also support up to two D7035 Octal Relay Modules (Remote Relay 1 and
Remote Relay 2), that offer a total of 16 remote relays (eight relays per module).The following
window appears:
RELAY OUTPUTS
1- LOCAL
2- REMOTE 1
3- REMOTE 2
4- MULTIPLEX
Press the number key that corresponds to your selection.
i
Notice!
The option for multiplex relay programming is visible only if the D7039 Multiplex Expander is
installed.
Local Relays
Shortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYS
The display scrolls through the Relay options.
Press [1] for LOCAL. The following window appears:
ONBOARD RELAY
(1-3):
Enter the number corresponding to the relay to be programmed and press [#/Enter]. The
display asks you to enter four zones to activate this output:
OUTPUT ZONE A:_______
(00 - 63):_______
Enter the first zone (00 to 63) you want to assign to this output and press [#/Enter]. A similar
display for Zones B, C and D will appear to allow up to four zones to be assigned to this
output. When all four zones are assigned, the previous window appears.
For pre-assigned zones, see Pre-assigned zone quick reference, 74.
An output point cannot be assigned to more than four zones. Each output does not need to be
assigned to four zones. Each zone can have any number of outputs assigned to it.
Remote relays
Shortcut: 0-PROG, 5-PROG OUTPUTS, 2-RELAYS
The display scrolls through the Relay options. Press [2] for REMOTE 1 or [3] for REMOTE 2.
The following window appears:
REMOTE RELAY @ x
(1 - 8):
8.5.2
76 en | Control Panel Programming Fire Alarm Control Panels
2012.08 | 04 | F01U008458 Installation and Operation Manual Bosch Security System, Inc.