Filter
Top Products
Teledyne API Model T360/T360M Operation Manual Operating Instructions
73
4.4. SETUP MODE
The SETUP mode contains a variety of choices that are used to configure the
analyzer’s hardware and software features, perform diagnostic procedures, gather
information on the instruments performance and configure or access data from
the internal data acquisition system (DAS). For a visual representation of the
software menu trees, refer to Appendix A. The areas access under the Setup mode
are presented in Table 4-4 and Table 4-5.
Table 4-4: Primary Setup Mode Features and Functions
MODE OR
FEATURE
TOUCHSCREEN
BUTTON
DESCRIPTION
Analyzer
Configuration
CFG
Lists key hardware and software configuration information
Auto Cal Feature
ACAL
Used to set up and operate the AutoCal feature.
Only appears if the analyzer has one of the internal valve
options installed
Internal Data
Acquisition (DAS)
DAS
Used to set up the DAS system and view recorded data
Analog Output
Reporting Range
Configuration
RNGE
Used to configure the output signals generated by the
instruments Analog outputs.
Calibration
Password Security
PASS
Turns the calibration password feature ON/OFF
Internal Clock
Configuration
CLK
Used to Set or adjust the instrument’s internal clock
Advanced SETUP
Features
MORE
This button accesses the instruments secondary setup menu
Table 4-5: Secondary Setup Mode Features and Functions
MODE OR FEATURE
TOUCHSCREEN
BUTTON
DESCRIPTION
External Communication
Channel Configuration
COMM
Used to set up and operate the analyzer’s various
external I/O channels including RS-232; RS-485,
modem communication and/or Ethernet access.
System Status Variables
VARS
Used to view various variables related to the
instruments current operational status
System Diagnostic Features
DIAG
Used to access a variety of functions that are used to
configure, test or diagnose problems with a variety of
the analyzer’s basic systems
CO
2
Concentration Alarms
ALRM
Used to activate the analyzer’s two gas concentration
status alarms and set the alarm limits
NOTE
Press ENTR to accept/apply changes made to a variable.
Press EXIT to ignore the change(s). (There will be an audible alert that the change has been lost).
07272B DCN6552