Filter
Top Products
Teledyne API Model T360/T360M Operation Manual Operating Instructions
167
To assign or reset the status flag bit assignments, press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X. HESSEN STATUS FLAGS
<SET SET> EDIT EXIT
SETUP X.X COMMUNICATIONS MENU
ID INET HESN COM1 COM2 EXIT
SETUP X. SYNC WARNING: 0000
PREV NEXT EDIT PRNT EXIT
Repeat pressing SET> until …
SETUP X. SYSTEM RESET: 0000
PREV NEXT EDIT PRNT EXIT
<CH and CH>
move the [ ]
cursor left and
right along the
bit string.
Repeat pressing NEXT or PREV until the desired
message flag is displayed. See Table 6-27.
For xxample …
ENT
R
accepts the new
settings
EXIT ignores the new
settings
SETUP X. SYSTEM RESET: [0]000
<CH CH> [0] ENTR EXIT
Press the [?] key repeatedly to cycle through the available character set:
0
-
9
Note: Values of A-F can also be set but are meaningless.
4.15.4.8. INSTRUMENT ID CODE
Each instrument on a Hessen Protocol network must have a unique ID code. The
T360 is programmed with a default ID code of 360 OR 0. To change this code
See Section 4.11.1
07272B DCN6552