Filter
Top Products
Teledyne API Model T360/T360M Operation Manual Operating Instructions
163
4.15.4.3. ACTIVATING HESSEN PROTOCOL
The first step in configuring the T360 to operate over a Hessen protocol network
is to activate the Hessen mode for com ports and configure the communication
parameters for the port(s) appropriately. Press:
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
Continue pressing next until …
Select which COMM
port to configure
SETUP X.X COM1 QUIET MODE: OFF
NEXT OFF ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : ON
PREV NEXT ON ENTR EXIT
SETUP X.X COM1 HESSEN PROTOCOL : OFF
PREV NEXT OFF ENTR EXIT
ENTR accepts the new
settings
EXIT ignores the new
settings
The sum of the mode
IDs of the selected
modes is displayed here
SETUP X.X COM1 E,7,1 MODE: ON
PR EV NEXT ON ENTR EXIT
SETUP X.X COM1 E,7,1 MODE: OFF
PREV NEXT OFF ENTR EXIT
Toggle OFF/ON to
change
activate/deactivate
selected mode.
Repeat the entire
process to set up
the COM2 port
07272B DCN6552