Teledyne T360M Carbon Monoxide Alarm User Manual


 
Teledyne API - T360/T360M, 360E/360EM Appendix A Menu Trees (05233C DCN6552)
A-11
APPENDIX A-2: 300 Series Setup Variables For Serial I/O, Revision L.8
Setup Variable Numeric
Units
Default
Value
Value Range Description
Low Access Level Setup Variables (818 password)
DAS_HOLD_OFF Minutes 15 0.5–20 Duration of DAS hold off period.
CONC_PRECISION — 3 AUTO,
0,
1,
2,
3,
4
Number of digits to display to the
right of the decimal point for
concentrations on the display.
REM_CAL_DURATION
17
Minutes 20 1–120
Duration of automatic calibration
initiated from TAI protocol.
STABIL_GAS — CO
0
CO,
CO2
10
,
O2
14
Selects gas for stability
measurement.
DYN_ZERO — OFF ON, OFF
ON enables remote dynamic
zero calibration; OFF disables it.
DYN_SPAN — OFF ON, OFF
ON enables remote dynamic
span calibration; OFF disables it.
CLOCK_ADJ Sec./Day 0 -60–60
Time-of-day clock speed
adjustment.
SERVICE_CLEAR — OFF OFF
ON
ON resets the service interval
timer.
TIME_SINCE_SVC Hours 0 0–500000 Time since last service.
SVC_INTERVAL Hours 0 0–100000
Sets the interval between service
reminders.
Medium Access Level Setup Variables (929 password)
LANGUAGE_SELECT — ENGL
0
ENGL,
SECD,
EXTN
Selects the language to use for
the user interface.
MAINT_TIMEOUT Hours 2 0.1–100
Time until automatically
switching out of software-
controlled maintenance mode.
LATCH_WARNINGS — ON ON, OFF
ON enables latching warning
messages; OFF disables latching
DAYLIGHTSAVING_ENABLE — ON ON, OFF
ON enables Daylight Saving
Time change; OFF disables
DST.
CONV_TIME — 33 MS
0
33 MS,
66 MS,
133 MS,
266 MS,
533 MS,
1 SEC,
2 SEC
Conversion time for
measure/reference detector
channel.
07272B DCN6552