Filter
Top Products
Teledyne API Model T360/T360M Operation Manual Introduction
19
Option
Option
Number
Description/Notes
Communication Cables For remote serial, network and Internet communication with the analyzer.
Type Description
60A RS-232
Shielded, straight-through DB-9F to DB-25M cable, about 1.8 m long.
Used to interface with older computers or code activated switches with
DB-25 serial connectors.
60B RS-232 Shielded, straight-through DB-9F to DB-9F cable of about 1.8 m length.
60C Ethernet Patch cable, 2 meters long, used for Internet and LAN communications.
60D USB
Cable for direct connection between instrument (rear panel USB port) and
personal computer.
USB Port For remote connection
64A
For connection to personal computer. (Separate option only when Option 64B, Analog
Input and USB Com Port, not elected).
Concentration Alarm
Relays
Issues warning when gas concentration exceeds limits set by user.
61
Four (4) “dry contact” relays on the rear panel of the instrument. This relay option is
different from and in addition to the “Contact Closures” that come standard on all
TAPI instruments.
RS-232 Multidrop Enables communications between host computer and up to eight analyzers.
62
Multidrop card seated on the analyzer’s CPU card. Each instrument in the multidrop
network requres this card and a communications cable (Option 60B).
Other Gas Options Second gas sensor and gas conditioners
65A Oxygen (O
2
) Sensor
Special Features Built in features, software activated
N/A
Maintenance Mode Switch, located inside the instrument, places the analyzer in
maintenance mode where it can continue sampling, yet ignore calibration, diagnostic,
and reset instrument commands. This feature is of particular use for instruments
connected to Multidrop or Hessen protocol networks.
Call Customer Service for activation.
N/A
Second Language Switch activates an alternate set of display messages in a
language other than the instrument’s default language.
Call Customer Service for a specially programmed Disk on Module containing the second
language.
N/A
Dilution Ratio Option allows the user to compensate for diluted sample gas, such as
in continuous emission monitoring (CEM) where the quality of gas in a smoke stack is
being tested and the sampling method used to remove the gas from the stack dilutes
the gas.
Call Customer Service for activation.
07272B DCN6552