Filter
Top Products
Teledyne API Model T360/T360M Operation Manual Operating Instructions
159
To initialize the modem press:
SETUP X.X SECONDARY SETUP MENU
COMM VARS DIAG ALRM EXIT
SETUP X.X PRIMARY SETUP MENU
CFG DAS RNGE PASS CLK MORE EXIT
SAMPLE* RANGE = 500.000 PPM CO2 =X.XXX
< TST TST > CAL SETUP
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
EXIT returns to
the previous
menu
SETUP X.X COM1 MODEM INIT:AT Y &D
&H
<SET SET> EDIT EXIT
SETUP X.X COM1 INITIALIZE MODEM
<SET SET> INIT EXIT
SETUP X.X COM1 MODE:0
SET> EDIT EXIT
SETUP X.X COM1 BAUD RATE:19200
<SET SET> EDIT EXIT
EXIT returns to the
Communications Menu.
SETUP X.X INITIALIZING MODEM
<SET SET> INIT EXIT
4.15.2.7. COM PORT PASSWORD SECURITY
In order to provide security for remote access of the T360, a LOGON feature can
be enabled to require a password before the instrument will accept commands.
This is done by turning on the SECURITY MODE (Mode 4, Section 4.11.5).
Once the SECUR
ITY MODE is enabled, the following items apply.
A password is required before the port will respond or pass on commands.
If the port is inactive for one hour, it will automatically logoff, which can also
be achieved with the LOGOFF command.
Three unsuccessful attempts to log on with an incorrect password will cause
subsequent logins to be disabled for 1 hour, even if the correct password is
used.
If not logged on, the only active command is the '?' request for the help
screen.
The following messages will be returned at logon:
LOGON SUCCESSFUL - Correct password given
LOGON FAILED - Password not given or incorrect
LOGOFF SUCCESSFUL - Connection terminated successfully
To log on to the Model T360 analyzer with SECURITY MODE feature enabled,
type:
LOGON 940331
07272B DCN6552