Filter
Top Products
Monitoring and controlling a conference
75
̈ Change the configuration of the audio inputs and outputs as desired.
You configure the same settings as in the “
AUX-In/Out” menu of the
central unit (see “Configuring the audio inputs and outputs” on
page 105 of the SDC 8200 system manual).
y Use the volume sliders to set the volume of the audio signal available
at the corresponding audio output.
y Click the “Off” option button in the “Status” box to turn the
corresponding audio input or output off.
y Click the “On” option button to turn the corresponding audio input or
output on.
Note:
You can also turn the audio inputs and outputs on and off as described
in the previous section.
y From the “Channel” drop down list, choose the number of the
interpretation channel that is to be assigned to the corresponding
audio output. If you choose “0”, the floor channel is assigned.
y Click the “On” option button in the “Distance Conferencing” box to
prevent echo during remote conferencing (see “Setting up remote
conferences” on page 57 of the SDC 8200 system manual).
y Use the level sliders to set the input level of the corresponding audio
input.
y Click the “Off” option button in the “Status” box to turn the
corresponding audio input or output off.
Click the “On” option button to turn the corresponding audio input or
output on.
y Click the “Low” option button in the “Sensitivity” box to set a low
sensitivity for the corresponding audio input.
Click the “High” option button to set a high sensitivity for the
corresponding audio input.
̈ Change the configuration for an external equalizer as desired.
y Click the “On” option button in the “External Equalizer” box if an
external equalizer is connected to the central unit.
Caution!
If the “On” option button in the “External Equalizer” box is activated,
the central unit outputs the audio signals of the consoles’ microphones
via the audio output and not via the consoles’ built-in loudspeakers.
However, if no external equalizer is connected, no audio signals can be
heard through the consoles’ built-in loudspeakers.
̈ Click the “Close” button.
The configuration of the audio inputs and outputs is changed. All
changes are also displayed in the central unit’s operating menu.
Note:
If you change the configuration of the audio inputs and outputs via the
central unit’s operating menu, this is automatically detected by the
software and immediately displayed in the “AUX IN/OUT” dialog box.