Filter
Top Products
Concord Ultra
59
Set Up Schedules Menu
The SET UP SCHEDULES menu lets you set up time frames for light control and exception opening/
closing reports
. The system (all partitions) allows you to set up to 16 schedules (00–15).
Setting up schedules consists of setting a start and stop time for each schedule, then selecting
which days of the week the schedule will be active. You can also set up a rollover schedule,
which starts on one day and ends on another day. This saves programming time and leaves more
schedules available (in case they are needed later).
Rollover Schedule Example: To set up a schedule to rollover from Tuesday evening to Wednes-
day morning, set a schedule start time for 2200 (10:00
P.M.) and a stop time for 0500 (5:00 A.M.).
Set the schedule to turn on Tuesday. Because the stop time is set for morning, the system auto-
matically carries the schedule over to the next day.
If you use the same start and stop times described above and set the schedule to turn on Monday
through Friday, then one schedule will cover the entire week.
Touchpad Brightness (042)
Options (Default = 2)
This setting lets the user lighten or
darken the background on touchpad
displays. Each touchpad can be set
to compensate for lighting condi-
tions in the touchpad location.
¾
To adjust Touchpad Brightness:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows
TOUCHPAD BRIGHTNESS n (current setting).
3. Enter a setting from 0 (darkest background) to 3 (brightest background). The display flashes
the entered selection.
4. Press # and the display shows the new setting.
Volume (043)
Options (Default = 4)
This setting determines the vol-
ume level of status sounds from
speakers connected to the Phone
Interface/Voice Module.
¾
To adjust status sound Volume:
1. Press A or B until the display shows OPTIONS, then press #.
2. Next, press A or B until the display shows VOLUME n (current setting).
3. Enter a setting from 0 (off) to 7 (loudest). The display flashes the entered selection.
4. Press # and the display shows the new setting.
Voice Chime (044)
Options (Default = on)
This setting determines whether
speakers connected to the Phone
Interface/Voice Module announce
perimeter sensor/zone numbers that
are tripped when the Chime feature is
on. For example, “Sensor one open.”
¾
To turn Voice Chime off or on:
1. Press A or B until the display shows OPTIONS.
2. Press # then A or B until the display shows
VOICE CHIME OFF/ON (current set-
ting).
3.
Press 1 (off) or 2 (on). The display flashes the entered selection.
4. Press # and the display shows the new setting.
Chime On Close (045)
Options (Default = off)
When this setting is on, the panel
sounds a single chime when a perime-
ter door or window is closed.
¾
To turn Chime On Close off or on:
1. Press A or B until the display shows OPTIONS.
2. Press # then A or B until the display shows
CHIME ON CLOSE OFF/ON (current set-
ting).
3. Press 1 (off) or 2 (on). The display flashes the entered selection.
4. Press # and the display shows the new setting.