Filter
Top Products
Concord Ultra 58
Options Menu
The OPTIONS menu lets you set up the system for downloading and silent arming. You can also
adjust alphanumeric touchpad display brightness from this menu.
Latchkey Report (030nnn5
where nnn=user number
00-229)
User Codes-Reg. User Codes-User NNN (Defaults: 00-05 = on, 06-229 = off)
This setting determines whether or
not the user code causes a latch-
key report to be sent to a pager
when the code is used to change
arming levels.
¾
To assign the Latchkey Report attribute to user codes:
1. With the display showing USER CODES, press # and the display shows REGULAR USER
CODES.
2. Press #
and the display shows USER nnn (first available user number).
3. Press A or B to select the desired user number, then press #. The display shows
USER
nnn - nnnn
.
4. Press A or B until the display shows
LATCHKEY OFF/ON (current setting).
5. Press 1 (off) or 2 (on). The display flashes the entered setting.
6. Press # and the display shows the new setting.
Partition Master (partition 1:
0310, partition 2: 0311)
User Codes-Partition Master Code (Default = none)
The Partition Master Code provides
access to all system operations and user
programming for a single partition.
Note
You must be “in” the partition of the partition
master code you wish to change.
¾To change the Partition Master Code:
1. With the display showing USER CODES, press # then A or B until the display
shows
PARTITION MASTER CODE.
2. Press #
and the display shows PARTITION nnnn (current code).
3. Enter a new 4-digit code. The display flashes the entered code.
4. Press # and the display shows the new code.
System Master (320)
User Codes-System Master Code (Default = 1234)
The System Master Code
provides access to all sys-
tem operations and user
programming.
¾
To change the System Master Code:
1. With the display showing USER CODES, press # then A or B until the display shows SYSTEM
MASTER CODE
.
2. Press #
and the display shows SYSTEM MASTER nnnn (current code).
3. Enter a new 4-digit code. The display flashes the entered code.
4. Press # and display shows the new code.
Downloading (040)
Options (Default = on)
When this setting is on, the panel can communicate with Tool-
Box
®
software for programming the system from off-site.
Note
For this feature to work, the panel must be connected to a phone
line and be programmed with REMOTE ACCESS on, with a Down-
loader phone number, and with a Downloader code.
¾To turn Downloading off or on:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows
DOWNLOAD-
ING OFF/ON
(current setting).
3. Press 1 (off) or 2 (on). The display flashes the entered
selection.
4. Press # and the display shows the new setting.
Silent Arming (041)
Options (Default = off)
This setting determines whether or not the panel sounds
status beeps from sirens and the touchpad when the system
is armed.
Note
When this feature is on, the user does not need to press 5
(SILENT) before arming the system to prevent status sounds.
¾To turn Silent Arming off or on:
1. Press A or B until the display shows OPTIONS.
2. Press #, then A or B until the display shows SILENT ARMING
OFF/ON
(current setting).
3.
Press 1 (off) or 2 (on). The display flashes the entered selection.
4. Press # and the display shows the new setting.