Filter
Top Products
8. DISASSEMBLY
S-7200C
83
８-２１. Pulley and motor
1. Screw [3 pcs]
2. Pulley washer [3 pcs]
3. Pulley
4. Screw [3 pcs]
5. Screw
6. Ground wire
7. Set screw [Two at motor side] (Loosen)
8. Motor (Pull out)
(1) Screw
(2) Motor
(a) Screw hole
4393M
If the motor will not pull out …
1) Insert the two screws (1) which were removed from the end
of the motor into the screw holes (a) and tighten them.
The motor (2) will lift up and be easier to remove.
NOTE:
Tighten the left and right screws little by little and evenly.
2) Once the motor (2) can be removed, remove the screws (1).