Filter
Top Products
S-7200C
4.
FUNCTION SETTINGS (G50 OPERATION PANEL)
21
Error processing settings (650-)
No.
Setting
range
Initial
value
Setting
units
Setting details
650
OFF/
5-30
(seconds)
OFF 1
Time until buzzer stops (seconds)
OFF: Buzzer does not stop
5-30: Buzzer stops after the specified time
651
OFF/
1-30
（minutes）
3
(minutes)
1
Overtime error display
* If the thread wiper key is OFF, error displays do not appear.
OFF: None
1-30: After continuous operation for the set length of time, operation stops and
[E190] is displayed.
652
ON/OFF ON -
Needle up stop error display
OFF: None
ON: If the needle does not stop at the up position after thread trimming, [E111]
is displayed.
Specifications and destination settings (850-)
No.
Setting
range
Initial
value
Setting
units
Setting details
851 ON/OFF
(*1)
-
Treadle operation specifications
ON: Specifications for Europe and the Americas
・ If No. 001 is “OFF”
(When the treadle is returned to the neutral position after thread
trimming, the presser foot is lowered.)
* If the treadle is returned to the neutral position during thread trimming,
the presser foot does not rise.
・ If No. 001 is “ON”
After thread trimming, the presser foot rises.
The presser foot does not drop even when the treadle is returned to the
neutral position.
・ If No. 001 or No. 002 is “ON”
(Even after the treadle has been depressed to the 1st step and the
presser foot has dropped, the presser foot rises when the treadle is
returned to the neutral position.)
* If No. 852 and No. 057 are not both “ON” at the same time, the
presser foot lowering function at the treadle’s 1st step will be disabled.
OFF: Other specifications
・ The presser foot does not drop even when the treadle is returned to the
neutral position after thread trimming.
・ When the treadle is depressed backward or the knee switch changes
from ON to OFF, the presser foot drops.
(The presser foot does not rise at the treadle neutral position
regardless of the settings for No. 001 and No. 002.)
852 ON/OFF (*1) -
Presser foot lowering at the forward 1st step
ON: Enabled
OFF: Disabled
(*1) This is not initialized during initialization mode.
The initial value varies depending on the destination. For Europe and the Americas, the initial setting is “ON”, and for all
other destinations are “OFF”.