Filter
Top Products
S-7200C
4. FUNCTION SETTINGS (G50 OPERATION PANEL)
14
Presser foot lifter and presser foot lifter pedal settings (050-)
No.
Setting
range
Initial
value
Setting
units
Setting details
050 ON/OFF ON -
Forward treadle operation interlock during thread trimming
ON: Depressing treadle forward during thread trimming is disabled
(After the treadle is returned to the neutral position, depressing it
forward is enabled.)
OFF: Depressing treadle forward during thread trimming is enabled
051 ON/OFF (*1) -
Operation after knee switch is used to raise and lower presser foot
ON: Presser foot can be raised and lowered by depressing the treadle
backward
OFF: Above operation is not possible
055 ON/OFF OFF -
Backward treadle operation when presser foot is lifted, or operation after
knee switch is operated
* This setting is only enabled when No. 851 is “ON” and No. 001 is “ON”.
ON: Presser foot does not lift when treadle is returned to neutral position
OFF: Presser foot lifts when treadle is returned to neutral position
057 ON/OFF (*1) -
Presser foot dropping when treadle is depressed forward to 1st step
* This is disabled when No. 852 is set to “OFF”.
ON: Presser foot is lowered
OFF: Presser foot is not lowered
(*1) The initial value varies depending on the destination. For Europe and the Americas, the initial setting is “ON”, and for all
other destinations, it is “OFF”.