Filter
Top Products
S-7200C
4.
FUNCTION SETTINGS (G50 OPERATION PANEL)
11
Sewing program settings (400-)
No.
Setting
range
Initial
value
Setting
units
Setting details
400 2-6 2 1
Start backtack sewing pattern
* If A=0, there is no A operation, and if B=0, there is no B operation.
2: A-B
3: B-A-B
4: A-B-A-B
5: B-A-B-A-B
6: A-B-A-B-A-B
401 2-6 2 1
End backtack sewing pattern
* If C=0, there is no C operation, and if D=0, there is no D operation.
2: C-D
3: C-D-C
4: C-D-C-D
5: C-D-C-D-C
6: C-D-C-D-C-D
402 1-2 1 1
Continuous backtack sewing pattern
1: A-B-C-D
* If A=0, there is no A operation, and if B=0, there is no B operation.
If C=0, there is no C operation, and if D=0, there is no D operation.
2: A-B × D times
* If A=0, there is no A operation, and if B=0, there is no B operation.
If A≠0, B≠0 and D=4, operation is in the order A-B-A-B.
403 ON/OFF OFF -
Stopping while start backtacking is in progress, and speed during start
backtacking
ON: When the treadle is returned to the neutral position, start backtacking can be
stopped before it is finished, and the speed during start backtacking
becomes the speed corresponding to the treadle depression amount.
(low speed-start backtacking speed)
OFF: When the treadle is returned to the neutral position, start backtacking ends,
sewing stops and the sewing speed becomes the start backtacking speed.
404 ON/OFF OFF -
Feed direction when sewing is stopped immediately after start
backtacking is complete
ON: Quick reverse solenoid turns OFF after sewing stops
* If No. 403 is “OFF”, operation occurs when the treadle is
depressed slightly.
OFF: Quick reverse solenoid turns OFF and feed returns to
normal direction, then stops
* If No. 452 is “ON”, the operation set by this setting is
disabled.
405 1-2 1 1
Operation when pleat presser sewing key is ON (fixed stitch sewing load
function)
1: Reverse stitching operation when actuator switch is ON
2: Fixed stitch sewing operation when actuator switch is ON