Filter
Top Products
S-7200C
13. SETTING METHOD FOR STANDARD DEPRESSION STROKES
141
１３
. SETTING METHOD FOR STANDARD DEPRESSION STROKES
DANGER
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet
before opening the face plate of the control box. Touching areas where high voltages are present can result in
severe injury.
Use the following procedure to set the operating positions for the depression stroke.
１３-１. When using the G50 operation panel
1
Signal setting entry
(Press the power OFF switch, and then set DIP switch No. 4 to ON.)
2
“PdFF x.xxx” will appear in the main
display (1). (x.xxx indicates the depression
voltage.)
(While pressing the key, press the power ON switch.)
3
Memorizing the maximum forward position
“Pdnn x.xxx” will appear in the main
display (1).
(With the treadle depressed forward to the maximum forward position,
press the thread trimming key.)
4
Memorizing the neutral position
"Pdrr x.xxx" will appear in the main
display (1).
(With your foot released from the treadle, press the thread trimming key.)
Control box
2104B
2105B 2138M
2106B
2107B