Filter
Top Products
S-7200C
5. FUNCTION SETTINGS (G10 OPERATION PANEL)
51
５-７. Protection settings
1
Set the power switch to OFF, and then set DIP switch 1 to OFF.
2
Change to protect setting mode
(While pressing the key and the start backtack key,
press the power
ON switch.)
3
Set the protection level (0 to 3)
[If set to level 0 – 2]
4
Confirm the protection level (example: set to level 2)
5
[PLV] and the protection level will be displayed in the
display. (* is the protection level. At the time of shipment
from the factory, the protection level is set to “1”.)
Protect setting mode will be exited and normal operation will be possible
.
NOTE:
The range for disabling operation varies depending on the setting
for DIP switch 1.
For details, refer to <Protection setting list”> (P.53).
* If the protection level is different from the original value, the
protection level will flash in the display.
4206M
(Protection level)
(Flashing)
(Illuminated)
2074B 2138M
2033B
2075B