Filter
Top Products
S-7200C
4. FUNCTION SETTINGS (G50 OPERATION PANEL)
20
Standard device settings (550-)
No.
Setting
range
Initial
value
Setting
units
Setting details
550 0-1
0
(*1)
1
Automatic presser foot lifter type
0: Solenoid type
(Duty during chopping can be changed using No. 565.)
1: Pneumatic type
(Duty during chopping can be changed using No. 566.)
551
0-500
(ms)
150
(ms)
10
(ms)
Sewing machine motor start delay time when presser foot is raised
555
-345-345
(degrees)
0
(degrees)
1
Quick reverse solenoid on timing during start backtacking/continuous
backtacking
556
-345-345
(degrees)
0
(degrees)
1
Quick reverse solenoid off timing during start backtacking/continuous
backtacking
557
-345-345
(degrees)
0
(degrees)
1 Quick reverse solenoid off timing during end backtacking
558
-345-345
(degrees)
0
(degrees)
1
Quick reverse solenoid on timing during end backtacking
* This is only enabled when No. 451 is set to “ON”.
560
10-200
(ms)
20
(ms)
10
(ms)
561
10-200
(ms)
50
(ms)
10
(ms)
562
10-200
(ms)
50
(ms)
10
(ms)
Thread wiping and presser foot lift operation timing after thread trimming
563
10-990
(ms)
300 (ms)
10
(ms)
Presser foot lifter solenoid fully ON time
564
0-240
(seconds)
180
(seconds)
1
Presser foot lift time
0: No timer function (does not drop)
1-240: Presser foot drops after set time
565
10-60
(%)
25
(%)
1
On duty when solenoid-type presser lifter solenoid is chopping
* This is only enabled when No. 550 is set to “0”.
566
10-60
(%)
50
(%)
1
On duty when pneumatic-type presser lifter solenoid is chopping
* This is only enabled when No. 550 is set to “1”.
567 0-1 0 1
Presser foot soft down mode
0: Automatic mode (This can be adjusted using No. 569.)
1: Manual mode (This must be adjusted using No. 568.)
568
20-120
(ms)
40
(ms)
5
(ms)
Delay time for presser foot lifter solenoid to turn on after presser foot drop
command
* This is only enabled when No. 567 is set to “1”.
569 10-12 12 1
Voltage detection constant for presser foot lifter solenoid to turn on after
presser foot drop command
* This is only enabled when No. 567 is set to “0”. If it is set to “10”, the
response time will be fastest and the operating sound will be loudest.
573
40-100
(ms)
85
(ms)
5
(ms)
Fully on time for quick reverse solenoid
574
10-60
(%)
40
(%)
1 On duty when quick reverse solenoid is chopping
(*1) This is not initialized during initialization mode.
2016B
Motor
Thread wiping
Presser foot lifting
Needle up stop