Filter
Top Products
S-7200C
12. APPLYING GREASE (-[]3[], []5[] SPECIFICATIONS)
139
１２-２. When “GrUP” appears ... When using the G10 operation panel
If “GrUP” flashes in the display (1) and the buzzer sounds when the power ON switch is pressed, it means that it is time to
add grease. (The sewing machine will not operate at this time, even if the treadle is depressed.)
Apply grease as required, while referring to the following for details.
* If the sewing machine is of –[]0[] specifications, it is a minimum lubrication-type sewing machine, and so there is no
need to add grease.
<To continue sewing without applying grease>
1. Press the thread wiper key (2).
2. The display (1) will change to stitch number display mode and sewing will be possible when the treadle is depressed.
NOTE
・ If you do not apply grease when the “GrUP” notification flashes, the notification will continue to flash each time the
power is turned on until you reset the notification by carrying out the procedure on the following page.
・ If you continue to use the sewing machine after the “GrUP” notification appears without applying grease (or without
carrying out the reset procedure), “E100” will appear after a certain period of time and the sewing machine will be
forcibly prevented from operating for safety reasons.
If this happens, apply grease and carry out the reset procedure.
* If you continue to use the sewing machine after carrying out the reset procedure but without applying grease,
problems with the sewing machine may result.
<Applying grease>
Use Brother-specified “Grease unit (SA8837-001)”.
4244M
4087M
Using the tube