Filter
Top Products
S-7200C
5. FUNCTION SETTINGS (G10 OPERATION PANEL)
43
５-５. Input checking method
This is used at the following times.
・ When there is a problem with an operation panel key, PCB or sensor
・ When you would like to check for broken cords
・ When you would like to adjust a sensor position
This lets you check if the CPU is reading signals from the keys and the sensors correctly.
1
Change to input check mode
2
Select the item number (A)
3
Change to input status display
4
Check the responses from the keys and switches, etc. while referring to the <Input check list> (P.44).
5
[To check another item number]
1)
2) Repeat steps 2 to 4 above.
6
Set the power switch to OFF and then turn the power back on again.
* If 2 seconds pass without no operations having been carried
out, the display will alternately show the item number and the
item name.
(Item number)
(Item number)
(Item name)
(Input status)
(Setting item)
2058B 2138M
2059B 2060B
2061B
2073B
(While pressing the key, press the
power ON switch.)
(Item number)