Filter
Top Products
S-7200C
4. FUNCTION SETTINGS (G50 OPERATION PANEL)
30
<Output check list >
The four characters on the left side of the main display on the operation panel show the item number/item name, and the
four characters on the right side show the output status.
Item No. Item name Output status Check item and checking method
[ 1] [ TRM] OFF
Thread trimming solenoid
When the treadle is depressed, the solenoid operates for 2 seconds.
When the treadle is returned to the neutral position, the solenoid
turns off.
[ 2] [ WIP] OFF
Thread wiper solenoid
When the treadle is depressed, the solenoid operates for 2 seconds.
When the treadle is returned to the neutral position, the solenoid
turns off.
[ 3] [ REV] OFF
Quick reverse solenoid
When the treadle is depressed, the solenoid operates for 2 seconds.
When the treadle is returned to the neutral position, the solenoid
turns off.
[ 4] [ PRE] OFF
Presser foot lifter solenoid
When the treadle is depressed, the solenoid operates for 2 seconds.
When the treadle is returned to the neutral position, the solenoid
turns off.
[ 5] [ OPT] OFF
Option solenoid signal
When the treadle is depressed, the solenoid signal turns on for 2
seconds.
When the treadle is returned to the neutral position, the solenoid
turns off.
[ 6] [INCH]
Inching speed operation
When the treadle is depressed, the upper shaft rotates at the inching
speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 7] [TRIM]
Thread trimming speed operation
When the treadle is depressed, the upper shaft rotates at the thread
trimming speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 8] [SLOW]
Slow speed operation
When the treadle is depressed, the upper shaft rotates at slow
speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 9] [ SBT]
Start backtack sewing speed operation
When the treadle is depressed, the upper shaft rotates at the start
backtack sewing speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 10] [ EBT]
End backtack sewing speed operation
When the treadle is depressed, the upper shaft rotates at the end
backtack sewing speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 11] [HIGH]
High speed operation
When the treadle is depressed, the upper shaft rotates at a speed
corresponding to the treadle depression amount (inching speed to
maximum speed).
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 12] [AUTO]
Automatic speed operation
When the treadle is depressed, the upper shaft rotates at the
automatic speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
[ 13] [ POS]
[****] [sti/min]
Shows the actual
sewing machine
speed
Stop improvement speed operation
When the treadle is depressed, the upper shaft rotates at the stop
improvement speed.
When the treadle is returned to the neutral position, the upper shaft
stops.
(Continued on next page.)