Filter
Top Products
Chapter 3 Configuring the Library 97
Chapter 3
For remote management, you need a network connection and a browser to:
■ View the current status of the library, drives, and tapes
■ Manage multiple devices from any workstation within the intranet
■ Manage and configure the library on your network in a secure
environment to:
— Clean the drives
— Load and unload tapes
—Run diagnostics
— Restart the library
— Dynamically assign the library’s IP address, gateway address, and
subnet mask using DHCP or BOOTP mode
■ View library, drive, and tape error messages
■ Generate error reports to fax or email to your support representative
■ Download and install firmware
■ Access web-based support, web registration, documentation, and partner
information
Dynamic Host Configuration Protocol (DHCP)
DHCP allows a DHCP server to dynamically assign IP addresses to any DHCP
client that requests one. The DHCP server usually has a limited set of IP
addresses, and assigns them on a first come first serve basis. When a DHCP
client boots up, it will broadcast a DHCP request over TCP/IP. If a DHCP server
is present, that server will respond to the DHCP client with an IP address,
subnet mask and gateway. This response also includes a lease (or expiration)
time for the IP address being assigned. If the DHCP client then wants to use this
address, the client must acknowledge the server’s response, and then
periodically renew the lease on that IP address. If the lease expires, the DHCP
server is free to re-issue that IP address to another DHCP client.
Note DHCP only manages dynamic allocation of IP addresses.
Assigning device names with DHCP is not recommended.