Filter
Top Products
Appendix Library Error Codes 213
Appendix C
51 33H Test not run, tapes not
in required locations.
The library needs at least one tape and an empty
slot to perform this test.
52 34H Test not run, an
inventory check is
needed.
■ Run the Inventory Check test from the front panel
(see Running Library Diagnostic Tests on
page 156).
■ Update the backup software to show the
correct tape and slot configuration.
53 35H Failed test, refer to
previous error.
Note the error code qualifier to help determine
appropriate testing.
54 36H Test not run, some
elements are reserved.
Check the backup software documentation to
disable the reserved condition.
56 38H Cannot run test with
tapes in current
locations.
The library needs at least one tape and an empty
slot to perform this test. For a drive test, it cannot
rewind the media.
57 39H Test not run, not
enough tapes in the
library.
Load one additional tape into the library.
58 3AH Test not started, the
transport contains a
tape.
Run the Empty Transport test (see Running Library
Diagnostic Tests on page 156).
59 3BH Failed to put tape into
magazine slot.
Note the error code qualifier to help determine
appropriate testing.
60 3CH Failed to get tape
from magazine slot.
Note the error code qualifier to help determine
appropriate testing.
61 3DH Failed inventory check
on a magazine slot.
■ Note the error code qualifier to help determine
appropriate testing.
■ Check magazine back slot for debris or marks.
Clean if necessary.
Table 46
Error Codes and Recovery Procedures
Decimal
Error
Hex
Error
Description Recovery Method