Filter
Top Products
Chapter 1 Moving or Shipping the Library 55
Chapter 1
The tape automatically rewinds before it is unloaded. A status screen
displays the library’s progress as the tape is relocated.
d. From the Drive and Tape Operations menu, select [Back] to return to
the Operations menu.
2. If shipping the library, remove tape cartridges from the magazines:
a. From the Magazine Access menu, select one of the following options:
—Unlock Door
—Unlock All Doors
Use the [-] and [+] keys to change the door selection.
b. Pull the unlocked drawer(s) out to access magazines and tapes. The
drawer may also be physically locked with a key. The key is typically
attached to the back of the power supply.
c. Remove the magazine by lifting it straight up with the handle.
d. To remove a tape, set the magazine on its back and grasp the top and
bottom corners of the tape. Pull the tape straight out of the magazine
and return the magazine to the library.
3. If shipping the library, lock the transport:
a. From the Administration menu, select the Run Test menu.
b. From Run Test, use the [-] or [+] keys to select Lock Transport.
c. Select [OK].
d. Select [Run]. The front panel display will indicate that the transport
has been locked.
Caution Do not power off the library until the interface is inactive.
Removing power from a SCSI or Fibre Channel peripheral when
the bus is active can result in data loss and/or indeterminate bus
states.
4. Power off the library. The power “standby” switch is recessed to avoid
accidental power cycles.