Filter
Top Products
Chapter 1 Getting Started 53
Chapter 1
Getting Started
After you install and configure the library, you must complete the following
setup tasks from the library’s front panel:
■ Setting the date and time: When you first set up the library or if it has
been unplugged for an extended period of time (around 8 days), set the
library’s real-time clock. See Setting the Date and Time on page 108 for
more information.
■ Setting the mailslot configuration: The default setting is for a one-slot
mailslot. You can select a 0-slot, 1-slot, 1-magazine, or 2-magazine
mailslot. See Configuring the Mailslot on page 93 for more information.
Note Mailslot configuration must be set prior to installing the backup
software.
■ Configuring the library for web monitoring: You can monitor and
manage your library anywhere on the network through user friendly web
pages. See Using the Remote Management Card on page 96 for more
information.
■ Enabling the password: The library does not have an administrator
password enabled when it arrives. To ensure security and to get full use of
the remote management card, enable and select a password. Be sure to
remember this password. See Enabling and Changing the Password on
page 92 for more information.
Note You must first set a library password through the front panel to
configure the library using the remote management card (see
Enabling and Changing the Password on page 92).