Filter
Top Products
24 Installing the 2/20, 4/40 & 6/60 Series Libraries into a Rack Chapter 1
4/40 and 6/60 Series Libraries:
Use a mechanical lift that is rated to the weight of the library, and follow
the steps below to install the library.
a. Break away the edges of the packing material at the bottom of the
library.
b. Use the straps to ease the library onto an appropriately rated
mechanical lift. Use the lift to raise the library so that it aligns with the
bottom rails.
c. Slide the library onto the lower rails. Have at least one person guide
the library from the front and one person pull the library from the
back, using the vertical handle (Figure 8 on page 24).
d. Remove the lifting straps once the library is partially installed. Save
the straps for future use when moving the library.
Figure 8 Library Installation
Caution Do not push the library from the front. Use the handle shown in
Figure 8. DO NOT pull on the handle(s) located on the back of
the power supply or drive modules.