Filter
Top Products
178 Upgrading Firmware Chapter 5
Note The firmware download may take several minutes to complete.
Using the Remote Management Card (library and LTO drive firmware)
All library components, except drives, can be easily downloaded from the
remote management card.
Note The firmware file is available from HP Support at http://
www.hp.com/go/support. These files must be loaded onto the
local host computer before downloading firmware. First select
your product, and then make a selection from the
Downloads &
Drivers pull-down menu.
1. Once the library is configured for network access, enter the IP address
within your web browser to launch the Web-Based Library Administrator
pages. (See Using the Remote Management Card on page 96.)
Note The library administrator password is required for this process
and is not set by default. If the password is not set, you will not
be permitted to download firmware.
2. Select the [Configuration] tab from the main screen.
3. Select the [Firmware Download] button.
4. Enter the full pathname for the download file, or use the [Browse] button
to locate the file.
5. Select the [Start Firmware Download] button to begin the actual process
of downloading the library firmware.
Once the download process begins, the progress and status of the
download will display on the lower half of your screen.
Note The firmware download may take several minutes to complete.