Filter
Top Products
44 Connecting and Powering on the Library Chapter 1
7. For 8/80 and 10/100 Series Libraries:
Connect the power cords on the rack to a power outlet on each library
level.
For 2/20, 4/40, and 6/60 series libraries, skip to the next step.
8. Connect the power cord(s) from the library to a grounded power
receptacle, and power on the library. The power (standby) switch is
recessed and on the lowest level of the library.
After the power-up test is complete (after several minutes), you will see the
Home Screen on the library’s front panel. The Home Screen displays the
status of the drives and library.
9. From the front panel, configure the library for Fibre Channel. See
Configuring the Library for Fibre Channel on page 102 for more
information.
10. Connect a category 5 ethernet cable from the remote management card to
an active network port (see Using the Remote Management Card on
page 96).
11. Power on the host.