Filter
Top Products
52 Verifying the Host Configuration Chapter 1
Sun Solaris
For Sun Solaris™ operating systems, perform the following operating system
configurations:
■ Install the appropriate host bus adapter(s)
■ Install the corresponding drivers for the interface card(s)
■ To verify the hardware installation, look for the library and drives after
powering up the host.
— Close all open applications and exit the Common Desktop
Environment (CDE).
— Type “init 0” at any prompt. This will shut down all processes, and
take you to the OpenBoot PROM.
— Type “reset”.
— At the OK prompt, type “probe-scsi-all”.
■ Install the backup software
■ Run a test backup to ensure that all components are properly configured.
HP-UX and MPE/iX
For more information on configuring these operating systems and verifying the
connection, see the online configuration and diagnostic guide at http://
www.hp.com/go/support. Select your product and then select [manuals].