Mitsubishi Electronics SW1DNC-GXW2-E Water System User Manual


 
3.4.2 Batch monitoring of device values
3 - 35
1
OVERVIEW
2
CREATED PROGRAM
AND SYSTEM
CONFIGURATION
3
CREATING PROGRAM IN
STRUCTURED LADDER/
FBD LANGUAGE
4
CREATING
PROGRAM IN ST
LANGUAGE
5
CREATING TWO OR
MORE PROGRAM
BLOCKS
3.4 Monitoring Operations
4. Set the Display Format of the device to be
monitored.
Setting on the Display Format screen
Monitor Format : Bit and Word
Display : 16 bit Integer
•Value : DEC
Bit Order : 0-F
Switch No. of Points : Bit Device Bit and Word
Format 16 Points
After the setting, click the button to close
the Display Format screen.
Refer to the following manual for the details on
Display Format.
GX Works2 Version 1 Operating Manual
(Common)
5. Click (Start Monitoring) on the toolbar to
start monitoring.
6. Set the programmable controller CPU to RUN.
Set the RUN/STOP switch on the programmable
controller CPU to "RUN".
7. Click (Stop Monitoring) on the toolbar to
stop monitoring.
Monitored values remain even after GX Works2
stops monitoring.
You can save the contents set on the Display Format screen.
When the monitoring screen is opened again, the contents set previously on the Display Format
screen will not be displayed. (The default setting will be displayed.) To display the previous
setting, you can save the setting to a file, and read the file. To save the setting, click Save
Display Format on the Device/Buffer Memory Batch Monitor screen. To read the saved setting,
click Open Display Format on the Device/Buffer Memory Batch screen Monitor screen.
Current value
(To the next page)