3.2.6 Creating a program
3 - 15
1
OVERVIEW
2
CREATED PROGRAM
AND SYSTEM
CONFIGURATION
3
CREATING PROGRAM IN
STRUCTURED LADDER/
FBD LANGUAGE
4
CREATING
PROGRAM IN ST
LANGUAGE
5
CREATING TWO OR
MORE PROGRAM
BLOCKS
3.2 Creating a Project
11.Draw a grid line (1) using the procedure
described in the step 3.
• After drawing a grid line, click (Select Mode)
on the Structured Ladder/FBD toolbar to specify
the Select mode.
12.Select a ladder block, and click (New
Ladder Block After) on the Structured Ladder/
FBD toolbar to add a ladder block.
Create a one Structured Ladder program in one ladder block.
13.Click (Open Contact) on the Structured
Ladder/FBD toolbar, and then move the cursor
to a desired position to display an open contact
there.
Click the open contact to connect it with the left bus
line and enable setting of a variable.
Settings
• Variable: X1
14.Select "Function" "MOVP" on the Function
Block Selection window, drag it, and drop it in a
desired position to position "MOVP" there.
Draw a grid line on the left figure (position 1) using
the procedure described in the step 3.
Click "?" of "s" and "d", and set the input and output
variables.
Settings
•s: 10
•d: VAR1
*1
*1: The label VAR1 is set in Section 3.2.5.
1)
Select a ladder block.
Variable
Input variable "s"
Output variable "d"
1)
(To the next page)