Mitsubishi Electronics SW1DNC-GXW2-E Water System User Manual


 
3.2.7 Compiling a program
3 - 19
1
OVERVIEW
2
CREATED PROGRAM
AND SYSTEM
CONFIGURATION
3
CREATING PROGRAM IN
STRUCTURED LADDER/
FBD LANGUAGE
4
CREATING
PROGRAM IN ST
LANGUAGE
5
CREATING TWO OR
MORE PROGRAM
BLOCKS
3.2 Creating a Project
3.2.7 Compiling a program
There are two types of compiling shown below. The compile target is different between the two types.
Select "Rebuild All" here.
The "Rebuild All" procedure is described below.
Refer to the following manual for compiling:
GX Works2 Version 1 Operating Manual (Structured Project)
Table 3.1 Compiling type and target program
Target program to be compiled
Build
Converts non-compiled program blocks among program blocks registered in the task into
sequence program. (Does not compile already compiled program blocks.)
Rebuild All
Converts all program blocks registered in the task into sequence program.
(Compiles already compiled program blocks also.)
1. Select [Compile] [Rebuild All] to execute
"Rebuild All".
You can click (Rebuild All) to execute "Rebuild
All".
2. The screen shown on the left appears.
Click the button to execute "Rebuild All".
If an error is detected, the Output window is
displayed.
Make sure to compile the created or edited program to make it a sequence program executable in the
programmable controller CPU.
"Warning C9062" is compiled correctly as a program, and can be monitored.
Compile status checking method
You can check the compile status on the Project view.
Each non-compiled portion is displayed in red.