Filter
Top Products
(SPAN)
Function Group
Menu Map
Description
Programming Codes
See Also
FREQUENCY
2
This
softkey
lets you set a value for the frequency span in the center
frequency/frequency span mode of swept frequency operation.
Press
w),
and use the entry area to enter the desired value.
The synthesizer sweeps from the span below to above the center
frequency.
Certain center frequency and frequency span combinations cause the
synthesizer to limit the value entered. In general, any combination
that causes the synthesizer to exceed its minimum or maximum
specified frequency is limited.
SCPI:
FREQuency:SPAN
<num>[freq
suffix] or
MAXimum]MINimum]UP]DOWN
FREQuency:MODE
SWEep
Analyzer: DF <num>
[Hz]Kz]Mz]Gz]
[CENTER),
ETxq,
(STOP)
“Center Frequency/Span Operation,” in Chapter 1.
Function Group
FREQUENCY
Menu Map
2
Description
This
softkey
activates swept frequency mode and makes the start
frequency parameter the active function. Press
CSTART)
and use the
entry area to enter the desired value. The start/stop frequency must
be separated by at least 2 Hz in order to remain in the frequency
sweep mode. If start=stop frequency then the zero span mode is
entered.
HP 8360
User’s Handbook
Operating and Programming Reference
S-61