Filter
Top Products
Mudule
Select Rear
Function Group
POWER and FREQUENCY
Menu Map
2 and 5
Description
This command causes the synthesizer to examine only the rear
panel source module interface connector to determine the type
of source module (if any) connected. The instrument frequency
limits and multiplier are altered according to the source module
connected. However, the leveling point is not changed. See
Leveling Point Module to set the synthesizer to level at the
output of the source module.
An asterisk next to the key label indicates this feature is active.
Programming Codes
SCPI:
SYSTem:MMHead:SELect
FRONt(REARINONE
SYSTem:MMHead:SELect?
Analyzer: NONE
See Also
Module Menu
Monitor Menu
Function Group (MOD)
Menu Map
4
Description
This
softkey
(Option 002 only) accesses the menu which allows you
to output internally-generated AM and FM waveforms to the rear
panel AM/FM OUTPUT connector. It also accesses the softkeys
which allow you to display the AM depth and FM deviation of the
modulation waveforms.
ModOut
On/Off AM
Outputs the AM waveform to the AM/FM
OUTPUT connector.
Modflut
On/Off
FM
Outputs the FM waveform to the AM/FM
OUTPUT connector.
Meter On/Off AM
Displays the AM depth of the modulating
signal.
M-28
Operating and Programming Reference
HP 8360
User’s Handbook