Filter
Top Products
SCPI
COMMAND SUMMARY
FREQ:MODE Affect on Slope
CW or LIST
Rotates around 0 Hz.
SWEep
or
Rotates around the start frequency.
STEP
The *RST value is 0.
l
POWer:SLOPe:STATe ON|OFF|l|O
l
POWer:SLOPe:STATe?
Sets and queries the power slope state. *RST value is 0.
l
POWer:SPAN
<num>[DB]
lMAXimumlMINimumlUPlDOWN
l
POWer : SPAN?
[MAXimum
I
MINimum]
The coupling equations for power sweep are exactly analogous to
those for frequency sweep. Power sweep is allowed to be negative,
unlike frequency sweeps. *RST value is 0.
l
P0Wer:STAR-t
<num>~lvlsuffixllMAXimumlMINimumIUPlDOWN
l
POWer:STARt?
[MAXimumlMINimuml
Default units and units for query response are determined by the
command UNIT : POWer. The coupling equations for power sweep
are exactly analogous to those for frequency sweep. Power sweep is
allowed to be negative, unlike frequency sweeps.
*RST
value is 0
dBm.
l
POWer:STATe ON|OFF|l|O
l
POWer:STATe?
Sets and queries the output power on/off state. *RST value is OFF.
l
POWer:STEP:AUTO
ON|OFF|l|O
l
POWer:STEP:AUTO?
Sets and queries the function switch that controls how the power
step size (Power: STEP:
INCRement)
is determined. if in the automatic
state, then the step size is 1
dB.
The *RST setting is ON.
l
POWer : STEP
[
:
INCRementI
<nu.m>
[DB]
I
MAXimum
1
MINimum
l
POWer : STEP
[
:
INCRementI
?
[MAXimum I
MINimumI
Sets and queries the power step size to be used for any node in the
power subsystem that allows UP and DOWN as parameters. Setting this
value explicitly causes POWer : STEP : AUTO OFF.
The
*RST
setting is 10 dB.
l
POWer:STOP
Qn.un>[lvlsuffix]
lMAXimumlMINimumlUPlDOWN
l
POWer : STOP?
[MAXimum I MINimumI
Sets and queries the ending power for a power sweep. Default units
and units for query response are determined by the command
UNIT:POWer. The coupling equations for power sweep are exactly
HP 8360
User’s Handbook
Operating and Programming Reference
S-45